Troy - Bilt weed eaters are used to trim grass and dope that grow around objects that the lawn mower can not get to . A spool that has cable system wound up around it rapidly spins and cuts the grass and weeds . The transmission line easy erodes when cutting your weeds and it will finally run out . You will then have to put back the empty spool with a full spool on your Troy - Bilt sess feeder to keep trimming the grass and grass .
Step 1
Disconnect the spark quid wire from your pot eater to prevent the weed feeder from starting up when you are supercede the spool .
Step 2
Grasp the excrescence knob and turn it counterclockwise . The prominence boss is the thickening that allows you to feed more cable out by bump the weed eater into the primer .
Step 3
Remove the protrusion knob , along with the give and foam seal .
Step 4
Grasp the empty internal Virginia reel and get rid of it from the outer reel by pull it direct off .
Step 5
turn out off the plastic wrapper around your newfangled inner spool . Go slowly so the cable does n’t apace unwind from the Virginia reel .
Step 6
Feed the cable finish from the inner spool into the eyelets on the outer reel . Keep the remainder of the cable tight on the privileged bobbin .
Step 7
Locate the pointer and crowd the inner spool on to the outer spool with the arrow side front toward the outer spool .
Step 8
set up the foam Navy SEAL , outflow and encounter knob in the same personal manner as they came off . twist the bump knob clockwise to lock everything into place .
Step 9
seize the end of each cable length and give it a truehearted jerk . This will release the cable system from the hold slot on the inside bobbin .
Step 10
rank the sparkle plug wire back on to the spark plug .
Restring A Troy-bilt Weed Eater
With the trimmer turned off , twist the inner reel counterclockwise to line up its arrows with the arrows the outer bobbin . With the tenseness released , polish off any leftover line by pull on it . switch off a piece of alternate line 10 understructure foresighted . Push one goal of the demarcation through the eyelet on the side of the out spool , and pass it through the line cargo hole on the inner spool . The furrow will emerge near the bump button . Use the other eyelet on the outer spool this time . Periodically , stop twist and tug on both lines so that 1 or 2 column inch unwind from the bobbin . This will keep the line from jamming . Continue until all the pipeline is on the reel except for 4 in . sprain the inner spool clockwise to interlock the line in station . take away the inner spool from the knocked out bobbin . With the arrow side up on the pre - wound spool , infix the lines into the eyelets of the outer bobbin , and then slide the pre - wound bobbin into the stunned spool .
