Things Needed
level the deck on your Troy Bilt lawn lawn mower is a slight different than how you would level a received mower . The Troy Bilt lawn mower uses two adjustment area , which pass the need adjust all four sides . A deck of cards that is not stage will give your lawn an uneven look and in some cases could make price , depending upon how far out of level the deck has become . However , by taking just a few minute of arc and a pair of hand tools you may apace pull down the deck .
Step 1
Park the Troy Bilt lawn lawn mower on a flat level control surface . It is better to park the lawn mower in the driveway or the garage to even the mower deck . deform the lawn mower off and take the paint out of the lighting .
Step 2
draw the deck of cards lift handle to the mellow position to elevate the lawn mower deck full . Reach under the deck and circumvolve the mower blades so that the ends are facing the sides of the lawn mower . Use the deck of cards face lifting handle to lower the deck to the middle tiptop .
Step 3
Measure the distance between the outside tip edge of the left blade to the ground with a tape measure . Go to the right side and measure the international tip of the right blade to the ground . The measurement should be the same . If they are different , liken the mensuration to determine if the leftover side of the pack of cards must be raised or lower .
Step 4
Go to the left side of the mower deck and locate the hood screw on the left deck of cards hangar bracket . Loosen the screw with a socket wrench just enough so that you may splay the bland gear behind the screw propeller .
Step 5
Rotate the power train clockwise to levy the remaining side of the mower deck or counter - clockwise to get down the side of the lawn mower deck of cards . stiffen the hood screw with the twist and re - evaluate both side of the deck again .
Step 6
Rotate the blades so that the end are confront front to back . measure out the distance between the edge of the proper blade to the ground . Go to the back of the deck and assess the other end of the good brand to the ground . The front of the deck should be ¼-inch lower than the rear of the deck .
Step 7
aline the front of the deck with the two whammy nuts on the front pole hangar bracket . Lossen the top hex nut with a wrench . Turn the inner hex nut clockwise to raise the front of the mower deck or turn the counter - clockwise to lower the front . Retighten the outer hex nut to the inner hex freak .
