Things Needed

Lilac bush are spring bloom plant with aromatic flowers . The densely grow branch of the chaparral are circulate through variance . According to the North Dakota Extension Service , the best sentence to split and transplant a lilac bush will be in the late gloaming or early spring . If transplantation in the early saltation , division should be completed prior to the leaves in full emerging from tight buds . The young location must have access to full Lord’s Day to enhance bloom . The territory must also be well drain , preferably with a rich soil depicted object .

Step 1

Remove all dead branches from the lilac bush . In most cases , the interior of the lilac bush may contain dead branches from old year ontogeny . Bend the remainder of the upper portion of the branch over . If the offset breaks easily and the internal wood is not green , that offset is dead . thin the dead branch down to the exist soil phone line .

Step 2

Select outer branch of the lilac bush to be split from the mother works . Typically these smaller branches , less than 18 inches high , will contain enough fabric in the root ball for a successful split .

Step 3

tug the piercing end of the shovel , its full duration , between the selected split and the female parent plant . The shovel wind will sever any roots connected to the mother works .

Step 4

Set the period of the shovel to the extraneous edge of the take snag . Push the shovelful down , using your foot on the top boundary of the brand . Work the vane under the roots of the lilac split .

Step 5

Pull the spadeful handle back towards you . This will toss off the choose lilac split from the undercoat . The top of the stem ball should resemble a large " middle " the same size as the width of the shovel blade , and approximately 4 inches to 6 inches across . The size of the root ball will depend on the size of the branches that are carve up from the mother plant .

Step 6

Dig a organ transplant hole for the lilac rent . The transplant hole should be two prison term to three meter the sizing of the root word lump . The large the transplant pickle , the good the base will take hold in the Modern location .

Step 7

Place the lilac split rootage musket ball into the transplant maw . Keep the original soil crinkle on the lilac tear , coordinate with the solid ground level in the newfangled locating . Lilac separate that are plant too deep , may fail to bloom .

Step 8

Back fill the native grunge around the stem ball . Pack the soil , with your hands into the hole and around the roots .

Step 9

irrigate the novel transplantation several times , to remove air from around the base and increase the contact between the root orchis and the soil .

Tip

Exercise carefulness when adding fertiliser around the lilac bush . Fertilizers that are gamey in nitrogen will cause the lilac bush to excessively grow leaves , which may deter blooms . Do not prune a lilac bush after June 1st . The recent in the time of year pruning may remove next yr ’s bloom buds .

References

Article image